Jonsered CS 2252 Workshop Manual page 41

2
Make sure the cabling is fitted to its mounting on
the intake flange.
Press the fuel hose (D) in place in the collar on the
intake bellows.
Hook on the throttle cable (E) in its mounting on
the intake bellows. See figure 46.
Make sure the lug on the carburettor hooks in
place on its mounting on the intake system.
Make sure that the following components are
correctly fitted:
• Position the air filter holder against the carburet-
tor.
• Make sure the carburettor cover's intake channel
is aligned correctly with the slot for the air filter
holder.
• The spring must be fitted under the choke pin on
the carburettor. See figure 47.
• The rubber collar on the stop button must be on
the inside of the bottom of the carburettor com-
partment. See figure 47.
• NOTE! Make sure that the fuel and return hoses
are not crushed.
3
Position the guide taps on the air filter holder in the
rubber grommets, G. See figure 48.
4
Hook on the throttle cable, E. See figure 46.
Fasten the return hose B and secure it in its
mountings on the air filter holder.
Attach the pressure hose A, with the short hose on
the short plastic plug on the fuel pump.
Attach the tank bleeding hose, C. See figure 49.
5
Hook it on the left side and then the right side of
the carburettor in the rubber mounting. Then screw
the carburettor in place. See figure 48.
6
Fit the air filter.
Fig 46
Fig 47
Fig 48
Fig 49
Repair Instructions
D
E
41
English -