Replacing The Fuel Filter; Electrical System Maintenance; Servicing The Fuse - Toro 30327 Operator's Manual

Note: Now is the best time to install a new
fuel filter because the fuel tank is empty. Refer
to Replacing the Fuel Filter.
5. Install the fuel line onto the fuel filter. Slide
the hose clamp close to the valve to secure the
fuel line.
Figure 38
1. Fuel shut-off valve

Replacing the Fuel Filter

Replace the fuel filter after every 200 operating
hours or yearly, whichever occurs first.
Never install a dirty filter if it is removed from the
fuel line.
Note: Note how the fuel filter is installed.
Note: Wipe up any spilled fuel.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
3. Close fuel shut-off valve at fuel tank
(Figure 38).
Note: Remove the fuel line from the fuel
valve that is closest to the engine.
4. Squeeze the ends of the hose clamps together
and slide them away from the filter (Figure 39).
2. Clamp
Figure 39
1. Hose clamp
2. Fuel line
5. Remove the filter from the fuel lines.
6. Install a new filter and move the hose clamps
close to the filter.
7. Open fuel shut-off valve at fuel tank
(Figure 38).
8. Check for fuel leaks and repair if needed.
Electrical System
Maintenance

Servicing the Fuse

The electrical system is protected by a fuse. It
requires no maintenance. If the fuse blows check
component or circuit for malfunction or short.
To replace fuse pull out on the fuse (Figure 40)
to remove or replace it.
33
3. Filter