Installing The Hairpin Cotter Pins; Reading The Manual And Viewing; The Safety Video - Toro 30327 Operator's Manual

Step
6
Installing the Hairpin Cotter
Pins and Spacers
Parts needed for this step:
2 Hairpin cotter pin
6 Spacers
Procedure
Unused height-of-cut spacers may be stored on
posts and retained by a hairpin cotter.
Note: Make sure there is at least one spacer used
on each height-of-cut post.
1. Remove the existing rear hairpin cotter pins
from the rear height-of-cut posts (Figure 13).
2. Install a spacer onto both rear height-of-cut
posts and install the hairpin cotter pins
(Figure 13).
Figure 13
1. Hairpin cotter
2. Spacer
3. Install a spacer onto both front height-of-cut
posts and install the hairpin cotter pins.
4. On the opposite side of the muffler,
install unused spacers onto front and rear
height-of-cut pins and insert the hairpin cotter
pins (Figure 14).
3. Height-of-cut post (rear
shown)
Figure 14
1. Hairpin cotter
2. Unused spacers
Step
7
Reading the Manual and
Viewing the Safety Video
Parts needed for this step:
1 Operator's Manual
1
Engine Operator's Manual
1 Parts Catalog
1 Safety Video
1 Registration Card
1 Oil drain hose
Procedure
• Read the Operator's Manual.
• View the safety video.
• Fill out the registration card and mail it in or
register online at www.Toro.com.
• Use the oil drain hose when changing the
engine oil.
16
3. Height-of-cut post (front
shown)