Table of Contents
Advertisement
Adjusting the Height of Cut
Adjust the height of cut from 25 to 140 mm (1 to 5-1/2
inches) in 6 mm (1/4 inch) increments by moving the
clevis pin into different hole locations.
1.
With the engine running, push the deck-lift
switch rearward until the mower deck is fully
raised, and release the switch immediately.
2.
Rotate the height-of-cut pin until the roll pin
in it lines up with the slots in the holes in the
height-of-cut bracket and remove it
3.
Insert the height-of-cut pin into the hole
corresponding to the desired cutting height
(Figure
25).
Refer to the decal on the side of the deck-lift
plate for the heights of cut
4.
Using the deck-lift switch, move the deck height
out of the transport position (or 5-1/2 inches (140
mm) cutting height) and down to the selected
height.
Figure 25
1. Height-of-cut bracket
(Figure
25).
(Figure
25).
g227689
2. Height-of-cut pin
Adjusting the Anti-Scalp
Rollers
For maximum deck flotation, install the rollers 1 hole
position lower. Rollers should maintain a 6 mm (1/4
inch) clearance to the ground. Do not adjust the
rollers to support the deck.
1.
Park the machine on a level surface.
2.
Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
3.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
4.
Adjust the anti-scalp rollers as shown in
26,
Figure
27, and
1. Flange nut
2. Anti-scalp roller
28
EUTRAL
Figure
28.
Figure 26
3. Bushing
4. Bolt
-
LOCK
Figure
g227785
Advertisement
Table of Contents
