Table of Contents
Advertisement
Controls
Become familiar with all the controls before you start
the engine and operate the machine.
Control Panel
1. Horizon display monitor
2. Deck-lift switch
Horizon Display Monitor
Refer to the Software Guide for detailed information
explaining the operator interface that allows you to
access information, reset counters, modify system
settings, and troubleshoot the equipment.
Figure 5
3. Key switch
4. Blade-control switch
(power takeoff)
g225792
1. Screen
2. LED status light
Information Screen
The information screen displays information relative
to machine operation; refer to the Software Guide for
more information.
Buttons
The multi-functional buttons are located at the bottom
of the panel. The icons displayed on the information
screen above the buttons indicate the current function.
The buttons allow you to select the engine speed and
navigate through system menus.
Refer to the Software Guide for more information.
LED Status Light
The LED status light is multi-colored to indicate the
system status and is located on the right side of the
panel. During startup, the LED illuminates red to
orange to green to verify functionality.
•
Solid green—indicates normal operating activity
•
Blinking red—indicates an active fault
•
Blinking green and orange— indicates that a
clutch reset is required
Refer to the Software Guide for more information.
Alarm
If an error occurs, an error message displays, the LED
turns red, and the alarm sounds audibly as follows:
14
Figure 6
Horizon Display Monitor
3. Buttons
g228164
Advertisement
Table of Contents
