Table of Contents
Advertisement
Installation Instructions
Before installation
Be sure to configure the switches on the connector panel and bottom of
the unit before installing it.
Configuring the switches after the unit is installed may prove difficult.
IR ID switch settings
The IR ID switches are located on the connector panel of the unit.
G/L IN
AUDIO IN
RS-422
3G SDI OUT
IR ID
SERVICE
IR ID switch
CAM1
CAM2
These are used to select the ID of the wireless remote control (optional
accessory). (→ page 56)
The IR ID switch settings "CAM1" to "CAM4" correspond to the
CAMERA <1> to <4> buttons on the wireless remote control.
Service switch settings
The service switches are located on the connector panel of the unit.
Perform switch settings before turning the unit on.
Service switch
SW1
SW2 SW3 SW4
ON
OFF
G/L IN
RS-422
3G SDI OUT
SERVICE
IR ID
Function
SW1
Switches for initialization
(Refer to the explanations in "Initialization 1"
and "Initialization 2")
SW2
Always leave at OFF (used for factory
SW3
adjustments)
SW4
Initialization 1
• Reset the user authentication settings and host authentication settings
for network connection.
(This will delete all the registered user information (IDs/passwords)
and host information (IP addresses).)
• With the IR ID switches and service switches set as shown below, turn
on the power of the unit.
ON
OFF
<NOTE>
When initialization is complete, the status display lamp on the front of
the unit blinks green. Set the service switches back to their original
positions (SW1 to SW4 all OFF), then restart the unit.
8
DC IN 12V
LAN
LINK
ACT
CAM3
CAM4
DC IN 12V
AUDIO IN
LAN
LINK
ACT
Factory settings
OFF
OFF
OFF
OFF
SW1
SW2 SW3 SW4
Initialization 2
• The unit is reset to the state it was in at the time of purchase. (All
camera menu setting values and network setting values are reset.)
• With the IR ID switches and service switches set as shown below, turn
on the power of the unit.
OFF
<NOTE>
• When initialization is complete, the status display lamp on the front
of the unit blinks green. Set the service switches back to their original
positions (SW1 to SW4 all OFF), then restart the unit.
Setting the installation method ("Desktop" or
„
„
"Hanging") from the OSD menu
Set "Desktop" or "Hanging" in [Install Position] on the [Pan/Tilt] screen
from the OSD menu of this unit.
P an / T i l t
I n s t al l P o si t i o n
P / T Sp e e d Mo d e
P / T Ac c e l e ra t i o n S e t t in g
S p e e d W i t h Z o o m P o s i t io n
F o c u s A d j u st W i th P T Z .
P r i v ac y M o de
P o w e r O n P os i t i on
P r e se t N u mb e r
R e t u rn
Install Position [Desktop, Hanging]
[Desktop] or [Hanging] is selected here as the method used to install
the unit.
Desktop
Stand-alone installation
Hanging
Suspended installation
<NOTE>
• When [Hanging] has been selected, the top, bottom, left and right
of the images will be reversed, and up/down/left/right control for
panning and tilting will also be reversed.
SW1
SW2 SW3 SW4
ON
De s k t o p
N o r ma l ( 6 0d e g / s )
O n
O f f
O f f
St a n d b y
0 0 1
Advertisement
Table of Contents
