Improper Combustion; Gas; When Servicing The Appliance; Water Quality - Westinghouse WBRC 140W Series Installation Manual

B. IMPROPER COMBUSTION
Do not obstruct the flow of combustion and ventilating air. Adequate air must be provided for safe operation. Failure to keep the
exhaust vent and intake pipe clear of ice, snow, or other debris could result in property damage, serious personal injury, or death.
C. GAS
Should overheating or gas supply fail to shut off, do not turn off or disconnect electrical supply to the circulator. Instead, shut off the gas
supply at a location external to the appliance.
D. WHEN SERVICING THE APPLIANCE

To avoid electric shock, disconnect electrical supply before performing maintenance.

To avoid severe burns, allow appliance to cool.

Do not use petroleum-based cleaning or sealing compounds in an appliance system. Gaskets and seals in the system may be
damaged, possibly resulting in substantial property damage.

Do not use "homemade cures" or "patent medicines". Substantial property damage, damage to appliance, and/or serious
personal injury may result.

Always verify proper operation after servicing the appliance.
E. WATER QUALITY
Potable water is defined as drinkable water supplied from utility or well water in compliance with EPA secondary maximum contaminant
levels (40 CFR Part 143.3) as shown in Table 2. It is important to ensure the water quality is within these determined limits. If your
water contains contaminants higher than outlined by EPA, then water treatment is recommended and additional maintenance may be
required. If you suspect that your water is contaminated in any way, discontinue use of the appliance and contact an authorized
technician or licensed professional.
Contaminant
Total Hardness
Aluminum
Chloride
Copper
Iron
Table 2 – Water Quality Specifications
F. FREEZE PROTECTION
Consider appliance piping and installation when determining appliance location.
NOTE: Damages resulting from incorrect installation or from use of products not approved by
Westinghouse ARE NOT covered by warranty.
G. SCALDING
APPROXIMATE TIME / TEMPERATURE RELATIONSHIPS IN SCALDS
o
120 F
o
125 F
o
130 F
o
135 F
o
140 F
o
145 F
o
150 F
o
155 F
Table 3 – Time and Temperature Relationship in Scalds
This heater can deliver scalding water. Be careful whenever using hot water to avoid scalding
injury. Certain appliances, such as dishwashers and automatic clothes washers may require
increased water temperature. By setting the thermostat on this heater to obtain the increased
water temperature required by these appliances, you may create the potential for scald injury.
To protect against injury, you should install a mixing valve in the water system. This valve will
reduce point of discharge temperature by mixing cold and hot water in branch supply lines.
Such valves are available from your local plumbing supplier.
Maximum Allowable Level
200 mg/l (12 grains/gallon)
0.05 to 0.2 mg/l
250 mg/l
1 mg/l
0.3 mg/l
More than 5 minutes
1 ½ to 2 minutes
About 30 seconds
About 10 seconds
Less than 5 seconds
Less than 3 seconds
About 1 ½ seconds
About 1 second
Contaminant
Manganese
pH
Sulfate
Total Dissolved Solids (TDS)
Zinc
Maximum Allowable Level
0.05 mg/l
6.5-8.5
205 mg/l
500 mg/l
205 mg/l
WHL-012 REV. 4.8.16
10