Advertisement
Available languages
Available languages
CARE AN D MAI NTE NANCE OF YOU R G RI LL
C A U T I O N
SPIDER ALERT!
SPIDERS AND WEBS
INSIDE BURNER
If your grill is getting hard to light or the flame is weak, check and clean the
venturis and burners.
Spiders or small insects are known to create "flashback" problems by building
nests and laying eggs in the grill's venturi or burner, obstructing the flow of
gas. The back-up gas can ignite behind the control panel. This flashback can
damage your grill and cause injury. To prevent flashbacks and ensure good per-
formance the burner and venturi tube assembly should be removed and cleaned
when ever the grill has been idle for an extended period of time.
G e n e r a l G r i l l C l e a n i n g
•
Do not mistake brown or black accumulation of grease and smoke for paint.
Interiors of gas grills are not painted at the factory (and should never be painted).
Apply a strong solution of detergent and water or use a grill cleaner with scrub
brush on insides of grill lid and bottom. Rinse and allow to completely air dry. Do
not apply a caustic grill/oven cleaner to painted surfaces.
•
Plastic parts: Wash with warm soapy water and wipe dry.
•
Do not use citrisol, abrasive cleaners, degreasers or a concentrated grill cleaner
on plastic parts. Damage to and failure of parts can result.
•
Painted surfaces: Wash with mild detergent or non-abrasive cleaner and warm
soapy water. Wipe dry with a soft non-abrasive cloth.
•
Stainless steel surfaces: To maintain your grill's high quality appearance, wash
with mild detergent and warm soapy water and wipe dry with a soft cloth after
each use. Baked-on grease deposits may require the use of an abrasive plastic
cleaning pad. Use only in direction of brushed finish to avoid damage. Do not use
abrasive pad on areas with graphics.
•
Cooking surfaces: If a bristle brush is used to clean any of the grill cooking
surfaces, ensure no loose bristles remain on cooking surfaces prior to grilling. It is
NOT recommended to clean cooking surfaces while grill is hot.
YOUR BURNER MIGHT BE DIFFERENT
S a f e t y T i p s
•
Before opening LP cylinder valve, check the coupling nut for tightness.
•
When grill is not in use, turn off all control knobs and LP cylinder valve.
•
Never move grill while in operation or still hot.
•
Some surfaces will be hot during use. Use long-handled barbecue utensils and
oven mitts to avoid burns and splatters.
•
The grease tray or cup must be installed during use and emptied after each use.
Do not remove grease tray or cup until grill has completely cooled.
•
Clean grill often, preferably after each cookout. If a bristle brush is used to clean
any of the grill cooking surfaces, ensure no loose bristles remain on cooking
surfaces prior to grilling. It is not recommended to clean cooking surfaces while
grill is hot.
•
If you notice grease or other hot material dripping from grill onto valve, hose or
regulator, turn off gas supply at once. Determine the cause, correct it, then clean
and inspect valve, hose and regulator before continuing. Perform a leak test.
•
Do not store objects or materials inside the grill cart enclosure that would block
the flow of combustion air to the underside of either the control panel or the
firebox bowl.
•
The regulator may make a humming or whistling noise during operation. This will
not affect safety or use of grill.
•
If you have a grill problem see the "Troubleshooting" Section.
•
If the regulator frosts, turn off grill and LP cylinder valve immediately. This in-
dicates a problem with the cylinder and it should not be used on any product.
Return to supplier!
S t o r i n g Yo u r G r i l l
•
Clean the cooking grates.
•
Remove excess grease from the firebox.
•
Store in dry location.
•
When LP cylinder is connected to grill, store outdoors in a well-ventilated space
and out of reach of children.
•
Cover grill if stored outdoors. Char-Broil offers a cover custom fit to your Grill at
charbroil.com.
•
Store grill indoors ONLY if LP cylinder is turned off and disconnected, removed
from grill and stored outdoors.
•
When removing grill from storage, follow "Cleaning the Burner Assembly" instruc-
tions before starting grill.
P a ge 9
C H A R B R O I L. C O M
Advertisement
