Maintenance
9.5 Repair
6. Slide the two roller tracks under the raised frame of the diode module. Use the screws which
7. Position the stacker with the pre-mounted changing device in such a way that the roller
8. Allow the diode module to slide down the roller tracks by unscrewing the connections on the
9. Pull the diode module onto the stacker. Secure the diode module with two additional stop
10.Remove the screwed connections for the roller tracks, which are now joined together.
Installing the module
1. Install the intact module in the reverse order of the previously described steps.
2. When tightening the screws, make sure that you use the appropriate torque (Page 143)
3. Tighten the joints between the water pipes by hand.
160
were previously used for the screwed connection of frame and insulators to fix the roller
tracks in place.
Figure 9-29
Changing device: joining the roller tracks
tracks under the diode module and the roller tracks on the stacker can be screwed together.
lugs.
Figure 9-30
Changing device: stop brackets
①
brackets
.
permissible for each screw type.
SINAMICS SM150 6SL3845-2NN41-8AD2
Operating Instructions Rev.201910281310 EXAMPLE