Table of Contents
Advertisement
S
t
e
p
3
.
T
e
s
t
i
n
g
S
t
e
p
3
.
T
e
s
t
i
n
g
The following test procedure checks to see if the scanner is properly functioning
with your computer and the scanning software. Before testing your scanner, double
check to make sure that all connections are securely fastened.
To properly test your scanner, please perform the following steps:
1. Insert the document or image face up into the scanner. Align the paper to the
arrow sign on the left of the scanner.
2. Press the SCAN button on the scanner. The scanning starts immediately.
3. When the scan completes, Presto! ImageFolio program opens.
4. If an image appears on your screen, your scanner is working properly.
If the test failed in any way, please refer to "Appendix A:
Troubleshooting" section of this manual and follow the instructions
therein.
Attention
Software Setup Troubleshooting
Carefully review the steps outlined in this guide and the Quick Guide that
accompanied your scanner.
If you are still having problems, please check that:
•
You have 250MB of free space on your hard disk drive.
•
The scanner is plugged in and has power.
•
You are using the USB cable supplied with the scanner.
•
The square end of the USB cable is plugged into the rear of the scanner.
•
The rectangular end of the USB cable is plugged into the back of your
computer.
If you deviated from the installation procedures defined in this manual, please
unplug the USB cable from the scanner and reinstall the software from the CD-ROM.
To reinstall your scanner's software, click [Start], [Run], then type D:\Setup (where D
t
h
e
S
c
a
n
n
e
r
t
h
e
S
c
a
n
n
e
r
9
Advertisement
Table of Contents
Troubleshooting
