Table of Contents
Advertisement
3.
Attach the other mounting bracket to the other side of the chassis in the same way.
Figure2-8 Attaching the mounting brackets to the switch
Attaching cage nuts and bottom support rails to the rack
1.
Identify and mark the cage nut installation holes on the rack for securing mounting brackets and
bottom support rails.
2.
Install cage nuts (user-supplied) in the marked mounting holes in the rack posts.
3.
Align the screw holes in one bottom support rail with the installation holes in the rack posts at
one side. Use the user-supplied M6 screws to attach the bottom support rail to the posts
(recommended torque: 30 kgf-cm), as shown in Figure2-9.
4.
Perform the same procedure to attach the other bottom support rail to the rack posts at the
other side.
Make sure the two bottom support rails are at the same height so that the bottom support rails
can slide into the chassis rails steadily.
Figure2-9 Installing bottom support rails
Attach cage nuts
to the rack
1
2
2-5
Attach bottom support rails
to the rack
Advertisement
Table of Contents
