Table of Contents
Advertisement
Figure2-23 Removing the filler panel from the interface module slot
1
Keep the removed filler panel secure for future use.
3.
Unpack the interface module.
4.
Press down and hold the latch of the ejector lever to pull the ejector lever out.
Figure2-24 LSWM116H interface module
1
2
(1) Latch
5.
Insert the module slowly into the slot along the guide rails, as shown by callout 1 in Figure2-25.
6.
Press down and hold the latch of the ejector lever to rotate the ejector lever to its original place,
Then release the grip on the latch to lock the ejector lever in place, as shown by callout 2 in
Figure2-25.
Figure2-25 Installing an LSWM116H interface module
2
2
1
2-15
(2) Ejector lever
Advertisement
Table of Contents
