Table of Contents
Advertisement
Section 2 - Basic Construction
2.1
Connectors
There are two (2) connectors supplied as an integral part of the Display.
2.1.1
Video Signal Connector
The video input signal cable will connect to a chassis mounted 15-pin female mini D-Shell connector
(AMP 748390-5 or equivalent) with socket contacts at the rear of the Display. Shielded for
electromagnetic interference (EMI) purposes, it shall perform electrical interconnection between the
Display and user logic. Refer to Section 4.1 for electrical connections.
2.1.2
DC Power Input Connector
The DC power input connector will be a chassis mounted 2-pin "MAT-N-LOK" style connector (AMP 1-
480699-0 or equivalent) at the rear of the Display. The connector housing incorporates male pin
contacts. Connections (Section 5.1) are insulated to insure no accidental contact.
2.2
Interface Cables
No interface cables are provided. Planar can provide suggestions on available cables.
2.3
LCD Controller Board
The LCD Controller Board incorporates components necessary to drive the LCD Panel (Section 6.5).
Accepting VGA and VESA video standards (Section 1.2), these video signals are digitized and processed
for the LCD Panel. Due to the LCD Panel's fixed video resolution (800 x 600), the LCD Controller Board
performs independent horizontal and vertical zoom and shrink scaling of specified video resolutions
less than or greater than the LCD Panel's video resolution to fully accommodate the LCD Panel's
capability.
Magnification of specified video resolutions to match the native LCD Panel's resolution incorporates
scaling algorithms minimizing aliasing and image distortion. The LCD Controller Board includes the
following characteristics:
•
Per pixel scaleable filters providing text sharpening and graphics smoothing for the highest
possible image quality.
•
Color depth enhancement by performing spatial-temporal dithering eliminating visual artifacts
resulting in clear and crisp text and graphics.
2.4
Grounding
Two (2) types of ground are provided:
2.4.1
Chassis Ground
The chassis ground is a conductor that is grounded to the earth within user circuitry. It may not be used
for current carrying purposes. It is to be used only for non-current carrying purposes such as
electromagnetic compatibility (EMC).
Title: Product Specification – LC08 High-Bright Monitor
Document Number: 023-0283-00
Chassis
Signal
and
ground.
Page 6 of 26
Rev C
Advertisement
Table of Contents
