Using Multi Operations; Using System Off - Pioneer Elite VSX-91TXH Operating Instructions Manual

Controlling the rest of your system
11
6 If necessary, press the input source button for the
component whose command you want to input.
This is only necessary if the command is for a new
component (input source).
7 Select the button for the command you want to
input.
The following remote control commands can be selected:
RECEIVER INPUT
SELECT
XM RADIO SIRIUS
DVD TV
CD-R/TAPE HDMI 2
iPod HDMI 1
SLEEP
SR+
DIALOG E
D.ACCESS
+10
AV PARAMETER
TOP MENU
TUNE
ST
SETUP
TUNE
GUIDE
• You don't need to program the receiver to switch on
or off. This is done automatically.
With Pioneer components, you don't need to:
• program the power to switch off in a shutdown
sequence (except DVD recorders);
• program the power to switch on if it's the source
component selected in step 3;
• program a Pioneer TV or monitor to switch on if the
input function (selected in step 2) has video input
terminals;
These take priority in multi operations (not shutdown).
8 Repeat steps 5–7 to program a sequence of up to
five commands.
When you're finished, use / to select EDITEXIT
9
from the menu and press ENTER.
You will return to the remote control SETUP menu. Select
* EXIT * again to exit.
Note
1 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes are sent.
70
En
SYSTEM OFF
SOURCE
TV CONTROL
INPUT
TV VOL TV CH VOL
SELECT
DVR 2
DVR 1 TV CTRL
CD ZONE 2 ANT REC INFO
TUNER RECEIVER
MUTE
REC STOP JUKEBOX
MPX
S.RETRIEVER ANALOG
ATT
AUDIO SUBTITLE HDD DVD
DIMMER MIDNIGHT/
LOUDNESS DISP CH CH
PHOTO
STEREO/
STATUS SIGNAL SEL SB ch
F.S.SURR
MULTI OPE THX STANDARD ADV.SURR
CLASS
DISC
ENTER
SHIFT
PHASE MCACC S.DIRECT
CH LEVEL
MENU
ST T.EDIT
ENTER
RETURN
RECEIVER
BAND

Using multi operations

You can start multi operations with the receiver switched
on, or in standby.
AUDIO SUBTITLE
DISP
STATUS SIGNAL SEL
MULTI OPE THX
SHIFT
PHASE
RECEIVER
1 Press MULTI OPE.
MULTI OP flashes in the display.
2 Press an input source button that has been set up
with a multi operation.
The receiver switches on (if it was in standby) and the
programmed multi operation is performed automatically.

Using System off

SYSTEM OFF
RECEIVER INPUT SOURCE
SELECT
XM RADIO SIRIUS DVR 2
DVD TV DVR 1 TV CTRL
1 Press MULTI OPE.
MULTI OP flashes in the display.
Press SOURCE .
2
The command sequence you programmed will run, then
all Pioneer components will switch off
receiver.
HDD DVD
CH CH
PHOTO
STEREO/
SB ch
F.S.SURR
STANDARD ADV.SURR
MCACC S.DIRECT
AUDIO SUBTITLE HDD DVD
DISP CH CH
PHOTO
STEREO/
STATUS SIGNAL SEL SB ch
F.S.SURR
MULTI OPE
THX STANDARD ADV.SURR
SHIFT
PHASE MCACC S.DIRECT
RECEIVER
1
, followed by this