Quick Launch Board - HP ProBook 4435s Maintenance And Service Manual

Quick Launch board

Description
Quick Launch board
Before removing the Quick Launch board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Bottom door (see
b. Hard drive (see
c. Optical drive (see
d. WLAN module (see
e. Fan (see
f. Heat sink (see
g. Keyboard (see
h. Top cover (see
Remove the Quick Launch board:
1. Position the top cover upside-down with the front toward you.
2. Remove the Phillips PM2.0×3.0 screw (1) that secures the board to the computer.
3. Remove the tape (2) that secures the cable to the computer.
Battery on page
Bottom door on page
Hard drive on page
Optical drive on page
WLAN/Bluetooth combo card on page
Fan on page 56)
Heat sink on page
Keyboard on page
Top cover on page
40).
41).
44)
42)
57)
61)
64)
Component replacement procedures
Spare part number
646362-001
49)
77