Mtl5514/ Mtl5514D/Mtl5514-T - Switch/Proximity Detector Interface - Eaton Crouse-Hinds MTL5500 Series Instruction Manual

6 .1 .7
Single channel, with line-fault detection and phase reversal
The MTL5514(-T) enables a safe-area load to be controlled, through a relay, by a proximity
detector or switch located in a hazardous area. Line faults are signalled through a separate relay
and indicated on the top of the module. The MTL5514D provides signal duplication, enabling
two safe-area loads to be controlled by a single device in a hazardous area. Both relay outputs
reflect the input signal instead of one showing the line fault condition as in the MTL5514. Line-
Fault Detect and Phase Reversal for the channel are selected by DIL switches on the side of
the module and output is provided by changeover relay contacts.
See page 19 for LFD and PR switch details. Channel 1 only switch settings apply.
For switch sensor inputs, with LFD selected, make sure resistors (22kΩ and 680Ω) are fitted.
Note: For reliable, long-term operation the load on the output switching relays should be not less
than 50mW, e.g. 10mA at 5V DC.
LFD
STS
MTL5514
PWR
Figure 6 .7:
Top label
for MTL5514 (-T)
& MTL5514D
27
MTL5514(-T)/MTL5514D - Switch/Proximity detector interface
Hazardous area
680Ω
+
22kΩ
–
Switch-type sensors
require resistors
if LFD is selected
Terminal
MTL5514 (-T)
1
2
7 LFD Output contact N.C.
8 LFD Output common
9 LFD Output contact N.O.
10 Output contact N.C.
11 Output common
12
Output contact N.O.
13
14
Safe area
6
7
5
LFD
8
LFD
4
9
3 10
O/P
2 11
12
1
13
14
20 to 35V dc
Function
MTL5514D
Input –ve (Ch 1)
Input +ve (Ch 1)
Output 2 contact N.C.
Output 2 common
Output 2 contact N.O.
Output 1 contact N.C.
Output 1 common
Output 1 contact N.O.
Supply –ve
Supply +ve
7
O/P2
8
9
10
O/P1
11
12
Vs–
Vs+
INM 5500 Rev 11