Safety Certification Information; Transmitter Adjustments; Display Options -Standard Display; Table 3 - Available Display Characteristics - Honeywell SmartLine ST 700 User Manual

2.3

Safety Certification Information

An "approvals" name plate is located on the bottom of the electronics housing assy; see
exact location. The approvals name plate contains information and service marks that disclose the
transmitter compliance information.
Refer to Section Appendix A in this document for safety certification requirements and details.
2.4

Transmitter Adjustments

Zero and Span adjustments are possible in ST 700 standard transmitter with the optional 3 button and
two-button assemblies.
You can also use the Honeywell MC Toolkit or other third-party hand-held configurator to make
adjustments to the ST 700 standard transmitter. Alternately, certain adjustments can be made through
the Experion or Universal Station, if the transmitter is digitally integrated with a Honeywell Experion
or TPS system.
Display Options – Standard Display
2.5
•
Basic display
•
•
•
•
•
Standard •
display
•
•
•
•
Page 6
Table 3 – Available Display Characteristics
Suitable for basic process needs.
360 o rotation in 90 o Increments.
2 lines, 16 characters.
Standard units of measurement: Pa, KPa, MPa, KGcm
inH O, mH O, bar, mbar, inHg, FTH
2 2
Diagnostic messaging.
Square root output indications.
o o
360 rotation in 90 Increments.
2 lines, 8 characters.
Standard units of measurement: Pressure Units:
o
atm, bar, ftH O68F, gf/cm
2
2
kgf/cm , kPa, mbar, mmH
psi, Torr, mH O4C, cmH
2
Flow Units (DP models only):
o
m3/hr, kg/hr, MT/hr, L/sec, L/hr, SCFH, CFH, gal/hr, bbl/hr, I/gal/hr,
%, SCFD, gal/min, Ib/hr, Ib/min, SCFM, MSCFH, MMSCFH.
Diagnostic messaging.
ST 700 SmartLine Pressure Transmitters User's Manual
O, mmH O, MMHG, & PSI.
2 2
2
, inH2O39F, inH O60F, inH
2
O4C, m, mH O68F, mmHg0C , MPa, Pa,
2 2
O4C
2
Figure 1 for
2 , TORR, ATM,
O68F, inHg0C,
2
Revision 13