Transit Call Control - D-Link DVG-6004S User Manual

DVG-6004S User's Manual

3-3-4 Transit Call Control

This is to control outgoing call and incoming call through FXO. Transit Call Control is effective when it
cooperates with Long-Distance Control Table. Long-Distance Exception Table is for an exception and it will not
be restricted by Transit Call Control and Long-Distance Control Table. You have to enable both of
Inbound/Outbound Call Control and PIN Code.
NOTE: Transit Call Control is active in one-stage dial.

Inbound Call Control: It is the inbound PIN code to check the calls from a PSTN network to FXO and
then using a VoIP when ticked － only effective for incoming calls calling from PSTN network.

Outbound Call Control: It is the outbound PIN code to check the calls from FXO to divert to PSTN
network when ticked － only effective for outgoing calls being diverted to PSTN network.

PIN Code: Enter the PIN code (4-6 digits or leave blank. A blank indicates no PIN code is required at
this level. Generally, the PIN at level 5 can remain blank to simplify the phone number.)

Enable: It is to activate the PIN code at each level when ticked.

Privileges: The level is divided into 0~5 (The levels are in descending order; 0 stands for the highest
authority and 5 stands for the lowest.)
The dialing principle to PIN Code is below:
* inbound call control PIN code * phone number
OR
* outbound call control PIN code * phone number
Using * to separate PIN code and the phone number is based on actual settings.
49
VoIP Gateway Configuration