Dtmf & Pulse - D-Link DVG-6004S User Manual

Hide thumbs Also See for DVG-6004S:

Table of Contents

DVG-6004S User's Manual

3-3-3 DTMF & PULSE

Advanced Settings → DTMF & PULSE

Dial Wait Timeout: Enter the timeout duration after the user picks up the phone set.

Inter Digits Timeout: Enter the timeout duration between the intervals of each key pressed. When

exceeding the set timeout duration without entering further digits, the numbers entered will be dialed out.

Minimum DTMF ON Length (Dial on)/ Minimum DTMF OFF Length (Dial off - between tones): This

variable is to set the length of DTMF playback.

DTMF Detection Sensitivity: Adjust DTMF detect threshold of duration.

DTMF Detection Volume Sensitivity: Adjust DTMF detect threshold of DTMF volume

DTMF Output Volume: Adjust the Tx volume of FXO port for DTMF Caller ID or Out of Band DTMF.

Enable Out-of-Band DTMF: This variable is to set the method of DTMF transmission. RFC2833 or SIP

Info.

Note: Out-of-Band DTMF transport method varies from VoIP networks, please contact your VoIP

provider for the preferred method.

Enable Hook Flash Event: Select Auto, RFC2833, or SIP info for the signaling method of Hook Flash

Event.

Payload Type: payload type of RFC2833.

Volume: Select the volume of RFC 2833 from the drop-down menu.

VoIP Gateway Configuration

Table of Contents