Woods BATWING BW20.51Q Operator's Manual page 75

LEFT WING ASSEMBLED
2
CD9120B
FOR LEFT ON MAIN CENTER
AND RIGHT WING
REF PART
1 1637
2 617144RP
3 617145RP
4 617146RP
5 1045624
HHCS
•
MAN1282
( 04/18/23 )
MAN1282_2023-04.indd 75 MAN1282_2023-04.indd 75
TANDEM ACCESSORY (OPTIONAL)
RIGHT WING ASSEMBLED
4
4
SPRING ARM
ON UNIT
1
2
3
4
QTY DESCRIPTION
8 HHCS 1/2 NC x 3-1/2 GR5 ZP
1 WA, right tandem arm, BW20
1 WA, left tandem arm, BW20
2 WA, tandem arm, BW20
8 HFN nut 1/2 NC, Dri-Loc patch
Hex head cap screw
Standard hardware; obtain locally
3
4
1
5
FOR RIGHT ON MAIN CENTER
AND LEFT WING
CENTER OF UNIT,
FORWARD
Installation Instructions
1. Raise unit and support with jack stands per diagram
on page 21 to take pressure off of tires.
2. Remove wheel assembly from right spring arm hub
assembly from center frame.
3. Remove axle hub from right spring arm.
4. Install drive type grease fitting in fitting in four holes in
spring arm.
5. Install tandem arm 617144 as shown.
6. Install tandem arm 617146 as shown, sliding both
axles into receiving tubes. Fasten with screw 1637
and nuts 1045624 provided.
7. Install axle/hub 1017050 and secure with screw 3489
and nut 1045624, reused or purchased separately as
needed.
8. Install wheel assembly.
9. Repeat for left spring arm of center frame, using
617145 in place of 617144, installed from the center.
10. Repeat for wings if purchased, noting orientation of
parts to locate wheels in the correct position. Outer
wheel should be forward of inner wheel on both wings.
5
Parts 75
4/18/23 2:55 PM 4/18/23 2:55 PM