Woods BATWING BW20.51Q Operator's Manual page 37

4. Repeat step to install second channel (10) on op-
posite wing.
5. Attach winch assembly to channels (10) using bolts
(5) and lock nuts (6).
6. Move SMV sign and hardware to channel as shown
in the winch kit instructions.
7. Tighten all hardware.
LA1
Figure 24. Winch Channel Installation
Winch Kit Operation
(Figure 25)
1. Move cutter so that wing is on the upward slope of a
ditch to aid in wing lift with the winch.
2. Unwind cable and remove roller (2).
3. Place cable around roller (2) and reinstall using pin
(3) and klik pin (4).
4. Attach cable hook into large hole in which assembly
bracket and raise wing.
5. Install transport lock pin before moving unit.
5
CENTER OF
CYLINDER LUG
6
2. 6696
3. 409
4. 22411 Klik pin, 3/16 x 1
Figure 25. Winch Kit Operation
MAN1282
( 04/18/23 )
MAN1282_2023-04.indd 37 MAN1282_2023-04.indd 37
10
9
8
7
(as needed)
Wing Lock-Up
Bracket
1
4
1
2
CD6947-3
Chain idler casting
Clevis pin, 1/2 x 2
Install Wing Wheel
(Figure 26)
1. Insert wheel hub into wing wheel yoke arms (5) and
align holes.
2. Secure into position using cap screw (83) and
flanged lock nut (88).
3. Attach wheel to hub using five lug nuts. Install the
chamfered side of the lug nut toward the inside for
steel rim for pneumatic tires and rims. Tighten to 85
lbs-ft. Check that tire air pressure is a maximum of
40 psi.
NOTE: Install the flat side of the nut toward the in-
side for solid tires and aircraft tires (shown).
4. Install optional dual wheel and hub to inside of
wheel yoke arm.
83
88
58
Chamfer
Install Tandem Accessory (Optional)
3
See Parts page 75 for parts list and diagram.
1. Raise unit and support with jack stands per diagram
on page 21 to take pressure off of tires.
2. Remove wheel assembly from right spring arm hub
assembly from center frame.
3. Remove axle hub from right spring arm.
4. Install drive type grease fitting in four holes in spring
arm.
5. Install tandem arm 617144 as shown.
6. Install tandem arm 617176 as shown, sliding both
axles into receiving tubes. Fasten with screw 3489
and nuts 1045624 provided.
Optional Wheel & Hub
5
5. Wing wheel yoke arm,
right
58. Wheel and hub
Flat
83. 1/2 NC x 3 HHCS GR5
88. 1/2 NC flanged lock nut
Figure 26. Wing Wheel - Right
Assembly 37
CD6800-4
4/18/23 2:54 PM 4/18/23 2:54 PM