Protecting The Environment - DeWalt DWV905M Original Instructions Manual

Hide thumbs Also See for DWV905M:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 28
Problem
Solution
Dust
1. Move three-position switch
extractor is
Tool Control™ mode . Confirm LED is
not turned
illuminated. If LED is not illuminated with
on by
the selector in Wireless Tool Control™ mode,
Wireless Tool
contact D
Control™
2. Remote/power tool is not paired to dust
equipped
extractor. Follow pairing steps.
power tool
3. Remote/power tool is out of range of dust
or remote.
extractor. Move dust extractor closer to
remote/power tool.
4. Wireless Tool Control™ remote coin cell is
dead. Replace coin cell and retry.
5. Ensure paired tool's battery is fully charged
and fully inserted.
6. If tank is full of liquid and sense circuit is
tripped:
a. Turn the three-position switch to the Off
(0) position and disconnect from power
source.
b. Empty tank.

Protecting the Environment

Separate collection. Products marked with this symbol
must not be disposed of with normal household waste.
w
Products contain materials that can be recovered or
recycled, reducing the demand for raw materials. Please
recycle electrical products according to local provisions. Further
information is available at www.2helpU.com.
Service
nOTE: If the dust extractor must be sent or returned for repair:
1. Contact the DEWALT service centre before sending or
returning in equipment to clarify possible hazards from
extracted hazardous materials. DEWALT service centre may
require only the vacuum head to be sent or returned. If
applicable, the DEWALT service centre will provide you a
protective packaging.
2. Observe the following instructions for personal protection
during transport and in the service centre:
a. Clean the tool thoroughly inside and out.
b. Remove the filter/disposal bag.
c. Apply the cleaning and disposal directions that are given
under Transportation, Maintenance and Cleaning sections
in the manual.
d. Please use the provided protective packaging, ensuring
that the plastic bag is sealed properly and is fully airtight
e. Attach a list of extracted hazardous materials to the
outside of the provided protective packaging.
16
to Wireless
WALT service centre.
e
EnGLIsH
35

Advertisement

Table of Contents
loading

Table of Contents