7 Configuration
—
1 Open the following (see
"4.2.1 To open the indoor
1 User interface panel
2 Switch box
3 Switch box cover
4 Top cover
2 Connect the solar input cable as shown in the illustration below.
A
B
13 14
X 5M
1
A
B
3 Fix the cable with cable ties to the cable tie mountings. General
information, see
"6.3.1 To connect the electrical wiring to the
unit" [ 4 17].
indoor
6.3.16
To connect the DHW output
Wires: 2×0.75 mm²
Maximum running current: 0.3 A, 230 V AC
—
1 Open the following (see
"4.2.1 To open the indoor
1 User interface panel
2 Switch box
3 Switch box cover
4 Top cover
2 Connect the DHW signal cable as shown in the illustration
below.
Installation manual
28
A
unit" [ 4 8]):
4
3
2
1
B
13 14
Solar input
3 Fix the cable with cable ties to the cable tie mountings. General
information, see
indoor
7
7.1
This chapter describes what you have to do and know to configure
the system after it is installed.
Why
unit" [ 4 8]):
4
If you do NOT configure the system correctly, it might NOT work as
3
expected. The configuration influences the following:
2
▪ The calculations of the software
1
▪ What you can see on and do with the user interface
How
You can configure the system via the user interface.
▪ First time – Configuration wizard. When you turn ON the user
interface for the first time (via the unit), the configuration wizard
starts to help you configure the system.
11 12
X 2M
1
"6.3.1 To connect the electrical wiring to the
unit" [ 4 17].
Configuration
INFORMATION
Cooling is only applicable in case of reversible models.
Overview: Configuration
NOTICE
This chapter explains only the basic configuration. For
more detailed explanation and background information,
see the installer reference guide.
11
12
DHW output
Max. load
0,3 A - 230 V AC
B
A
ETSH/X(B)16P30+50E
Daikin Altherma 3 H HT ECH₂O
4P679468-1B – 2022.09