Working With Breakpoints - Pacific Scientific OC950 Installation & Hardware Reference Manual

2.9 Working with Breakpoints

Introduction
Breakpoints allow you to halt program execution at a specific
location. 950IDE can set up to nine breakpoints within a
program. These should be set prior to running the program.
Setting
To set breakpoints:
breakpoints
1. Place the cursor on the line of code in which you want a
2. Select Set Breakpoint from the Debug menu or press <F9>.
Removing
To remove a breakpoint:
breakpoints
1. Place the cursor on the line of code which contains a
2. Select Clear Breakpoint from the Debug menu or press
3. To remove all breakpoints in a program, select Clear All
2 - 12
breakpoint set.
breakpoint that you want to clear.
<F9>.
Breakpoints from the Debug menu.
MA950