Table of Contents
Advertisement
You may now begin typing in your program. To create a simple
jog move, type in the following lines:
Note: The drive status display should now show a steady
configured and not enabled.
The current loop has been properly compensated for the selected
motor, and the servo parameters have been set to a medium
response (approximately 75 Hz velocity loop bandwidth) for the
unloaded motor. Additional default settings have also been
implemented.
Note: For additional tuning, click on the on-line tuning
button in the toolbar and follow the on-line help.
2.6.1 Using Wizards
Introduction
The following wizards have been added to the 950IDE to
facilitate creating programs:
•
•
•
•
•
2 - 8
Select Case
Modbus and A-B DF1 Map
Interrupt Handler
Move Command
Cam Setup
0
for
MA950
Advertisement
Table of Contents
