Replacement Procedures; Outer Cover Removal; Tools Required; Procedure - Agilent Technologies E4915A Service Manual

5

Replacement Procedures

Introduction
This chapter contains the procedures and lists the tools required to remove the major
assemblies from the E4915A/E4916A. To install an assembly, after you make repairs, reverse
the order of steps you performed for the removal of that assembly.

Outer Cover Removal

Tools Required

Pozidriv screwdriver, pt size #2 (medium)

Procedure

1. Disconnect the power cable from the E4915A/E4916A.
2. Remove the four bottom feet.
3. Remove the two outer cover screws from the rear panel.
4. Slide o the outer cover toward the rear and remove it.
Replacement Procedures 5-1