General Information
Introduction
This manual contains technical information concerning the adjustment, performance test, and
servicing of the E4915A/E4916A Crystal Impedance / LCR Meter.
Organization of Service Manual
Adjustments and Performance Tests provides instructions for adjustments and performance
tests of the instrument after repair or replacement of an assembly.
Replaceable Parts provides part numbers and illustrations of the replaceable assemblies and
miscellaneous chassis parts, together with ordering information.
Replacement Procedure provides procedures to disassemble portions of the instrument when
certain assemblies are to be replaced.
Board Conguration provides information on the jumper or bit switch settings of board
assembly.
Post Repair Procedures contains a table of adjustments/performance tests and other
verication procedures to be performed after repair or replacement of each assembly.
Appendices contains performance test record and messages.
Instruments Covered by Manual
Agilent Technologies uses a two-part, ten character serial number which is stamped on the
serial number plate (see Figure 1-1) attached to the rear panel. The rst ve letters are the
serial prex and the last ve digits are the sux. The prex is the same for all identical
instruments; it changes only when a change is made to the hardware of the E4915A/E4916A.
The sux, however, is assigned sequentially and is unique to each instrument. The contents of
this manual apply to instruments with the serial number prexes listed under Serial Numbers
on the title page.
1
General Information 1-1