National Instruments NI R Series Getting Started Manual page 5

Visit and enter the Info Code
ni.com/info
information.
Installing the PCIe-7857
1. Power off and unplug the computer.
2. Access the computer system expansion slots. This step might require you to remove one
or more access panels on the computer case.
3. Locate a compatible slot and remove the corresponding slot cover on the computer back
panel.
4. Touch any metal part of the computer to discharge any static electricity.
5. Insert the PCIe-7857 into the applicable PCI Express system slot. Gently rock the
PCIe-7857 into place. Do not force the device into place.
You cannot install PCI Express devices in PCI slots. PCI Express devices support up-
plugging into a PCI Express slot of higher lane width. For more information, refer to
ni.com/pciexpress.
1. PCI Express Device
2. PCI Express System Slot
3. PC with PCI Express Slot
6. Secure the module mounting bracket to the computer back panel rail.
7. Replace any access panels on the computer case.
8. Plug in and power on your computer.
9. If applicable, install accessories and/or terminal blocks as described in the installation
guides.
10. Attach sensors and signal lines to the device, terminal block, or accessory terminals.
4 | ni.com | NI PCIe-7857 Getting Started Guide
softwareversion
Figure 2. Installing a PCI Express Device
2
1
for minimum software support
3