Table of Contents
Advertisement
Update Rate is selected by default.
1. Use the up and down arrow (L K) keys to move the cursor to Interval. Push S, the Interval
option is selected.
2. Use the up and down arrow (L K) keys to move the cursor to H (Hour) input box.
3. Use the left and right arrow (N M) keys to adjust the Hour value.
4. Continue using the arrow keys to adjust the Minute and Second value.
5. Push 1 (Confirm) to take the adjustment into effect and back to main screen of Logger menu.
6. Push 2 (Cancel) to go back to the main screen of Logger menu without any change.
Item
Update rate
Interval
During logging, the user cannot switch screens and perform other measurement functions. If
the user tries to perform other operations, the Analyzer will prompt you to stop the logger.
The logger function is available in the Meter mode only. In other modes, when you push and
hold s, the Analyzer will show a message that indicates the Logger is only available in
Meter mode.
Even in Meter mode, the logger function is not supported if the user freezes the display with
h. You must exit the Hold mode first before you can use the Logger function.
Memory
1. Push m to enter the Memory interface.
The available file types are shown in
Table 28. Logger Interval
By update rate (default)
The logger interval is the update rate of the Analyzer.
The update rate is a kind of global configuration of the Analyzer. See
SyncSet Sync Source and Update Rate
Customize acquisition interval
Acquisition interval can be customized, the minimum interval is 1
second and the maximum is 24 hours
- H: Customize the Hour value of the interval.
- M: Customize the Minute value of the interval.
- S: Customize the Second value of the interval.
Table
29.
Description
for information on update rate.
Note
Power Analyzers
Operation
Set
57
Advertisement
Table of Contents
