Setting Temperature Display / Setting Beep On Alarm - Rheem IKONIC RTGH-S11i Training And Service Manual

SET POINT
BACK ENTER
STATUS SERVICE MODE
GENERAL INFORMATION
1.6.2 SETTING THE
TEMPERATURE DISPLAY
1. Press the " SETTINGS " button.
None
BACK ENTER
SETTINGS STATUS SERVICE MODE
2. Press the " ▼ " or " ▲ " button until "Temp Display"
is displayed, and press " ENTER " button.
Temp Display
BACK ENTER
SETTINGS STATUS SERVICE MODE
3. The factory setting is " Fahrenheit ". Press the " ▼ "
or " ▲ " button to select " Fahrenheit " and Celsius
", and press ENTER " to confirm. To exit this set-
ting, press BACK " button until the initial screen is
displayed.
Recirc.Pump Modes Tankless Config
BACK ENTER BACK
SETTINGS STATUS SERVICE MODE SETTINGS
SET POINT
BACK
SETTINGS
BACK ENTER
SETTINGS STATUS SERVICE MODE
Temp Display
BACK ENTER
SETTINGS STATUS SERVICE MODE
Fahrenheit
BACK ENTER
SETTINGS STATUS SERVICE MODE
SETTINGS
ENTER
STATUS SERVICE MODE
25
1.6.3 SETTING BEEP
ON ALARM
1. Press the " SETTINGS " button.
OFF
ENTER
STATUS SERVICE MODE
2. Press " ▼ " or " ▲ " button until " Beep On Alarm"
BACK
SETTINGS
3. The Factory setting is "NO". Press the "▼" or "▲"
Fahrenheit
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Modes
BACK
SETTINGS STATUS
IKONIC Tankless Water Heater Service Manual
SET POINT
BACK
SETTINGS STATUS
is displayed, and press " ENTER " button to con-
firm.
SET POINT
ENTER
STATUS SERVICE MODE
BACK
Beep On Alarm SETTINGS
BACK
SETTINGS STATUS
button to select NO " and YES ", and press "EN-
TER" to confirm. To exit this setting, press "BACK"
button until the initial screen is displayed
Yes
BACK
SETTINGS STATUS
ENTER
SERVICE MODE
ENTER
SERVICE MODE
SET POINT
ENTER
STATUS SERVICE MODE
ENTER
SERVICE MODE
ENTER
SERVICE MODE