Table of Contents
Advertisement
1.
(WWAN models) Remove the two Phillips M2.0 × 2.5 screws (1) from the WWAN bracket, and then
remove the bracket (2). Carefully disconnect the antenna cables from the WWAN module (3). Remove the
tape that secures the WWAN antenna cable to the battery (4), and then remove the cables from the clips
along the top of the battery and above the right speaker (5).
2.
Remove the speaker cables from the clips along the bottom of the battery (1).
3.
Disconnect the speaker cable from the system board (2).
4.
Remove the two Phillips M2.0 × 2.0 screws (3) from each speaker.
5.
Remove the speakers from the computer (4) .
To install the speakers, reverse this procedure.
Wireless charging module
To remove the wireless charging module, use this procedure and illustration.
Wireless charging module
35
Advertisement
Table of Contents
