Table of Contents
Advertisement
Setup Program
Programming securing stitches (Smart Secure)
Embroidery motifs are programmed with or without securing stitches. The machine detects if no securing
stitches are programmed and adds these.
> Touch the icon «Home».
> Touch the icon «Setup Program».
> Touch the icon «Embroidery settings».
> Touch the icon «Securing stitches on/off».
> To switch off securing stitches at the start, move the switch in the upper right-hand area to «0».
> To switch on securing stitches at the start, move the switch in the upper right-hand area to «I».
> To switch off securing stitches at the end, move the switch in the lower right-hand area to «0».
> To switch on securing stitches at the end, move the switch in the lower right-hand area to «I».
Adjusting the thread cut
The settings for the thread cut can be customized. Deactivate the thread cut after a color change (1) or
adjust the length of the connecting stitch (3). The machine does the cutting of the connecting threads at the
determined length for you. First, set the length from which the connecting stitches are cut, and then select
the embroidery motif.
The length of the connecting thread can be adjusted between 1 mm and 15 mm, the default setting is 6
mm. This means that all connecting stitches longer than 6 mm are cut automatically. If the value is
reduced to 1 mm, more thread cuts are carried out, it takes longer to embroider and more loose thread
ends can be seen on the wrong side of the fabrik. On the right side of the fabric there will be practically
none or merely very short connecting stitches which results in a wonderful stitch formation. Reducing the
length of the thread cut to 1 mm is particularly of advantage when embroidering texts where usually
many short connecting threads occur. As for other embroidery motifs (specifically when both sides of the
embroidery motifs are visible) it may be reasonable to not reduce the length of the thread cut so much so
that there won't be too many loose thread ends on the wrong side of the fabric. Loose ends get sewn
over and can hardly be removed afterwards.
52
– If the embroidery motif has programmed securing stitches, they will be embroidered.
– If the embroidery motif doesn't have any programmed securing stitches, none are embroidered.
– If the embroidery motif has programmed securing stitches, they will be embroidered.
– If the embroidery motif doesn't have any programmed securing stitches, the securing stitches are
added and will be embroidered.
– If the embroidery motif has programmed securing stitches, they will be embroidered.
– If the embroidery motif doesn't have any programmed securing stitches, none are embroidered.
– If the embroidery motif has programmed securing stitches, they will be embroidered.
– If the embroidery motif doesn't have any programmed securing stitches, the securing stitches are
added and will be embroidered.
Advertisement
Table of Contents
