Advertisement
telescope being on top of the mount head and
pointing to North Pole, with CW shaft pointing to
the ground.
To register, press MENU => Zero
Position => Set Zero Position.
confirm. One can also use MENU => Zero Position
=> Search Zero Position to set the Zero Position.
Go to an object: The mount is now ready for GOTO
13.
and tracking targets. Press MENU, select and ENTER
Select and Slew. Select a category (e.g., Solar
System), then select an object of interest (e.g.,
Moon). Press ENTER and the telescope will slew to
the object and automatically start tracking.
Sync to target: If the object is not in the center of
14.
the eyepiece, use this function to center and
synchronize the object to improve local GOTO
accuracy. Press MENU and select and ENTER Sync to
Target. Follow the on-screen instruction to perform
the sync.
[TIP: After slewing to an object, a list of nearby
bright object(s) can be displayed by pressing the ?
button.]
Computer connection and autoguiding: Please
15.
refer to CEM70 product page for mount computer
control.
Press ENTER to
iOptron Corp. | 6E Gill Street | Woburn, MA 01801 USA | (781) 569-0200 | www.iOptron.com
Put the mount back into the package/carrying
16.
case: It is recommended to return the mount to
Zero Position at the end of the observing session.
Lay the mount into the carrying case. Disengage the
gear system for transportation and insert the Allen
wrench into RA yoke to lock the RA axis.
CEM70-NUC and Cable Connection:
For a CEM70-NUC, the thickness of a NUC should be
less than 38mm, such as an Intel Frost Canyon with
"Slim" K chassis BXNUC10i3FNKN1.
Dovetail Saddle
Please contact
support@ioptron.com
support.
NUC
for technical
5
Advertisement
