A series, mount and telescopes, for 8600, 8602, 8603 and 8604 (48 pages)
Summary of Contents for iOptron CEM25
Page 1
Polar scope LED cable Controller cables X2 RS232‐RJ9 serial cable AC adapter – 100‐240V ONLINE RESOURCES (at www.iOptron.com, under “Support”) User’s Manual Tips for set up and using the products Hand controller and mount firmware upgrades (check online for the latest version) Reviews and feedbacks from other customers REV. 1.1 Packaging may change from time to time without notice. iOptron Corp. | 6E Gill Street | Woburn, MA 01801 USA | (781) 569-0200 | Toll Free (866) 399-4587 | www.iOptron.com ...
Page 2
Tripod Setup: The Alignment Peg should be at the north side for northern hemisphere, and vice versa. Thread the tripod Center Rod through tripod head iOptron Corp. | 6E Gill Street | Woburn, MA 01801 USA | (781) 569-0200 | Toll Free (866) 399-4587 | www.iOptron.com ...
Page 3
Gear Switch at OPEN position! Otherwise it might damage the worm system. With the corresponding Gear Switch in the OPEN Rear CW Position Screw position, balance the assembly in R.A. axis by moving CW along its shaft, and balance in DEC axis by moving iOptron Corp. | 6E Gill Street | Woburn, MA 01801 USA | (781) 569-0200 | Toll Free (866) 399-4587 | www.iOptron.com ...
Page 4
You may need to readjust the Tension Adjuster for 22, 2014, 20:19:42 in Boston, US (alt N42°30’32” different payload. and long W71°08’50”), 300 min behind UT, the Polaris Position is 0h45.8m and 40.4m. iOptron Corp. | 6E Gill Street | Woburn, MA 01801 USA | (781) 569-0200 | Toll Free (866) 399-4587 | www.iOptron.com ...
Page 5
Hemisphere. support@ioptron.com for technical supports. [TIPS: All time zones in N. America are “UTC ‐XXX minutes”. Latitude and longitude coordinates can be iOptron Corp. | 6E Gill Street | Woburn, MA 01801 USA | (781) 569-0200 | Toll Free (866) 399-4587 | www.iOptron.com ...
A. iOptron warrants your telescope, mount, or controller to be free from defects in materials and workmanship for two years. iOptron will repair or replace such product or part which, upon inspection by iOptron, is found to be defective in materials or workmanship. As a condition to the obligation of iOptron to repair or replace such product, the product must be returned to iOptron together with proof-of- purchase satisfactory to iOptron.