A series, mount and telescopes, for 8600, 8602, 8603 and 8604 (48 pages)
Summary of Contents for iOptron CEM60
Page 1
HC controller cable RS232‐RJ9 serial cable Polar scope LED cable AC adapter – 100‐240V Hard case Quick Start Guide (this document) Tripod NOT included ONLINE RESOURCES (at www.iOptron.com, under “Support”) User’s Manual Tips for set up and using the products Hand controller and mount firmware upgrades (check online for the latest version) Reviews and feedbacks from other customers The design and packaging may change from time to time without notice. REV. 2.0 iOptron Corp. | 6E Gill Street | Woburn, MA 01801 USA | (781) 569-0200 | www.iOptron.com ...
Page 2
Remove the alignment peg from a iOptron freely in RA axis. Make sure the RA gear switch is tripod/pier if it comes with one. Thread the two studs engaged before remove the SS lever. Use it to iOptron Corp. | 6E Gill Street | Woburn, MA 01801 USA | (781) 569-0200 | www.iOptron.com ...
Page 3
Gear Switches to prevent it from Screw in the back. swinging, which can cause personal injury and/or equipment damage. [TIP: If you latitudes is lower than 10°, please refer to the full online manual to adjust the counterweight The CEM gear system utilizes a magnetic force system shaft position to avoid CW bumping into tripod leg.] for optimal gear meshing. Fully turn the Gear Switch iOptron Corp. | 6E Gill Street | Woburn, MA 01801 USA | (781) 569-0200 | www.iOptron.com ...
Page 4
If the mount motor has “grinding” sound (which is not harmful) while slewing, the gear switch is too tight. Release 1/16 to 1/8 turn (clockwise, CW) and check it iOptron Corp. | 6E Gill Street | Woburn, MA 01801 USA | (781) 569-0200 | www.iOptron.com ...
Page 5
[TIPS: All time zones in N. America are “UTC ‐XXX minutes”. Latitude and longitude coordinates can be obtained from GPS‐equipped devices (navigator, support@ioptron.com for technical support. phone), or from internet and entered manually, if iOptron Corp. | 6E Gill Street | Woburn, MA 01801 USA | (781) 569-0200 | www.iOptron.com ...
A. iOptron warrants your telescope, mount, or controller to be free from defects in materials and workmanship for two years. iOptron will repair or replace such product or part which, upon inspection by iOptron, is found to be defective in materials or workmanship. As a condition to the obligation of iOptron to repair or replace such product, the product must be returned to iOptron together with proof-of- purchase satisfactory to iOptron.