Installing The 3.5-Inch Hard-Disk Drive Assembly (Bay-1) - Dell Precision 3660 Tower Service Manual

Next steps
1. Install the front bezel.
2. Install the side cover.
3. Follow the procedure in

Installing the 3.5-inch hard-disk drive assembly (Bay-1)

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the 3.5-inch hard-disk drive assembly and provides a visual representation of the
installation procedure.
Steps
1. Slide and insert the 3.5-inch hard-disk drive assembly into the hard-disk drive slot.
2. Route the power cable and the data cable through the routing guides on the hard-disk drive assembly and connect the
cables to the hard-disk drive.
Next steps
1. Install the front bezel.
2. Install the side cover.
3. Follow the procedure in
after working inside your
after working inside your
computer.
computer.
Removing and installing components 21