Steps
1. Align the screw holes on the processor fan and heat-sink assembly with the screw holes on the system board.
2. Tighten the four captive screws that secure the processor fan and heat-sink assembly to the system board.
3. Connect the processor-fan cable to the connector on the system board.
NOTE:
Ensure to connect the cable to the corresponding connector with same color on the system board.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
Power-supply unit
Removing the power-supply unit cover
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
NOTE:
Note the routing of all cables as you remove them so that you can route them correctly while you are replacing the
power-supply unit.
46
Removing and installing components
after working inside your
before working inside your
computer.
computer.