Removing Memory - Dell OptiPlex GX745 User'smanual

A matched pair of memory modules in connectors DIMM1 and DIMM2 (white securing clips)
B matched pair of memory modules in connectors DIMM3 and DIMM4 (black securing clips).
Addressing Memory With 4-GB or Greater Configurations (32-bit Operating Systems
Only)
This computer supports a maximum of 8 GB of memory. Current 32-bit operating systems, such as Microsoft® Windows® XP, can use a maximum of 4 GB of
address space; however, the amount of memory available to the operating system is less than that installed. Certain components within the computer require
address space in the 4-GB range. Any address space reserved for these components cannot be used by computer memory.
The following components require memory address space:
System ROM
l
APIC(s)
l
Integrated PCI devices, such as network connectors and SCSI controllers
l
PCI cards
l
Graphics card(s)
l
PCI Express cards (if applicable)
l
At start-up, the BIOS identifies the components that require address space. The BIOS dynamically calculates the amount of reserved address space required.
The BIOS then subtracts the reserved address space from 4 GB to determine the amount of usable space.
If the total installed computer memory is less than the usable address space, all installed computer memory is available for use only by the operating
l
system.
If the total installed computer memory is equal to or greater than the usable address space, a portion of installed memory is not available for use by
l
the operating system.
Removing Memory
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE: If you remove your original memory modules from the computer during a memory upgrade, keep them separate from any new modules that
you may have, even if you purchased the new modules from Dell. If possible, do not pair an original memory module with a new memory module.
Otherwise, your computer may not start properly.
You should install your original memory modules in pairs either in connectors DIMM1 and DIMM2 or connectors DIMM3 and DIMM4.
NOTICE: Removing memory modules from DIMM2 and DIMM4 on the desktop computer requires you to remove the optical drive (see Drives). Failure to
do so may cause damage to the memory module and the DIMM socket.
1. Follow the procedures in Before You
2. If you are using a desktop computer, remove the optical drive (see
3. Carefully press out the securing clip at each end of the memory module connector.
Begin.
Optical Drive).