Table of Contents
Advertisement
Back to Contents Page
Chassis Intrusion Switch
Dell™ OptiPlex™ 745 User's Guide
Removing the Chassis Intrusion Switch
Replacing the Chassis Intrusion Switch
Resetting the Chassis Intrusion Detector
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTE:
The chassis intrusion switch is optional on mini tower, desktop and small form-factor computers; it may not be present on your system.
Removing the Chassis Intrusion Switch
1. Follow the procedures in
Before You
2. Disconnect the chassis intrusion switch cable from the system board.
Note the routing of the chassis intrusion cable as you remove it from the chassis. Chassis hooks may hold the cable in place inside the chassis.
3. Slide the chassis intrusion switch out of its slot, and remove the switch and its attached cable from the computer.
Mini Tower Computer
Desktop Computer
Begin.
Advertisement
Table of Contents
Troubleshooting
