Fitting And Removing Safety Grilles - Volvo XC60 Owner's Manual

LOADING, STORAGE AND PASSENGER COMPARTMENT
||
IMPORTANT
The cargo cover may obscure the view to the
rear when in the loading position. Make sure
the cargo cover is fully extended or fully
retracted when driving.
Retracting
1. From the full-cover position:
Lift up the handle and pull it backward to dis-
engage the cargo cover's attachment pins
and then release.
From loading position:
Grip the handle and pull out the cargo cover
in the grooves - pull to the full-cover position.
Lift up the handle and pull it backward to dis-
engage the attachment pins and then
release.
2. Retract the cover with its attachment pins
outside of the side panels until it stops in the
retracted position.
Related information
• Fitting and removing cargo cover* (p. 608)
612

Fitting and removing safety grilles*

The safety grille prevents loads or pets in the
cargo area from being thrown forward in the
passenger compartment.
The safety grille is crash-tested in accordance
with the ECE R17 legal requirement and fulfils
Volvo's strength requirements.
For safety reasons, the safety grille must always
be attached and anchored correctly.
WARNING
Under no circumstances may anybody remain
in the cargo area while the car is moving. This
is to avoid injury in the event of heavy braking
or an accident.
Installation
IMPORTANT
The safety grille must only be used in the rear
position (behind the rear seat) described
here.
Before first installing the safety grille, the existing
plastic roof mountings must be replaced with
steel roof mountings. Volvo recommends that
replacing roof mountings is performed at an
authorised Volvo workshop or retailer.
1. Fold the rear seat's backrest forward.
2. Make sure that the safety grille is turned in
the right direction. Lift in the safety grille
through one of the rear side doors.
* Option/accessory.