Specific Installer Safety Instructions - Daikin RXTM30R2V1B Installer's Reference Manual

3 Specific installer safety instructions

RXTM-R_RXTP-R_ARXTP-R_RXTA-B
R32 split series
4P518023-11H – 2021.03
Always observe the following safety instructions and regulations.
To handle the outdoor unit (see
CAUTION
To avoid injury, do NOT touch the air inlet or aluminium fins of the unit.
Unit installation (see "6 Unit
WARNING
Installation shall be done by an installer, the choice of materials and installation shall
comply with the applicable legislation. In Europe, EN378 is the applicable standard.
"6.1 Preparing the installation
Installation site (see
CAUTION
▪
Check if the installation location can support the unit's weight. Poor installation is
hazardous. It can also cause vibrations or unusual operating noise.
▪
Provide sufficient service space.
▪
Do NOT install the unit so that it is in contact with a ceiling or a wall, as this may
cause vibrations.
WARNING
The appliance shall be stored so as to prevent mechanical damage and in a well-
ventilated room without continuously operating ignition sources (e.g. open flames,
an operating gas appliance, or an operating electric heater). The room size shall be as
specified in the General safety precaution.
Opening the unit (see "6.2 Opening the
DANGER: RISK OF ELECTROCUTION
Do NOT leave the unit unattended when the service cover is removed.
DANGER: RISK OF BURNING/SCALDING
DANGER: RISK OF ELECTROCUTION
Connecting the refrigerant piping (see
4
piping" [ 33])
CAUTION
Piping and joints of a split system shall be made with permanent joints when inside
an occupied space except joints directly connecting the piping to the indoor units.
3 Specific installer safety instructions
|
"4.2.2 To handle the outdoor
4
installation" [ 24])
site" [
4
unit" [ 28])
"7.2 Connecting the refrigerant
4
unit" [ 21])
4 24])
Installer reference guide
15