Power Over Ethernet Defaults; Understanding And Modifying The Default Settings - Alcatel-Lucent OmniSwitch 6860N Hardware User's Manual

Managing Power over Ethernet (PoE)

Power over Ethernet Defaults

The following table lists the defaults for PoE configuration:
Parameter Description
PoE operational status
Power available to a port
Power available to an entire
slot
Power priority level for a
port
Capacitor detection method
Priority disconnect status

Understanding and Modifying the Default Settings

The sections below provide information on each of the key components within the Power over Ethernet
software. They include information on PoE-related CLI commands. For detailed information on PoE-
related commands, refer to the OmniSwitch CLI Reference Guide.
Note. PoE units support different wattage power supplies. If unlike power supplies are mixed or if an
unsupported power supply is used, a console message and a trap are generated.
OmniSwitch 6860 Hardware Users Guide
Command(s)
lanpower slot service
lanpower power
lanpower slot maxpower
lanpower priority
lanpower capacitor-detec-
tion
lanpower slot priority-dis-
connect
October 2022
Power over Ethernet Defaults
Default Value/Comments
Disabled
OS6860 models:
- 30000 milliwatts on all ports.
OS6860E models:
- 60000 milliwatts on ports 1 through 4.
- 30000 milliwatts on ports 5 and higher.
OS6860E-P248Z8:
- 30000 milliwatts on ports 1 through 16.
- 75000 milliwatts on ports 17 through 24.
OS6860N-P48Z:
- 60000 milliwatts on ports 1-36.
- 95000 milliwatts on ports 37-48.
OS6860N-P48M:
- 95000 milliwatts on ports 1-48.
OS6860N-P24Z:
- 60000 milliwatts on ports 1-12.
- 95000 milliwatts on ports 13-24.
OS6860N-P24M:
- 95000 milliwatts on ports 1-24.
Use the show lanpower command to deter-
mine PoE power available.
low
Disabled
Enabled
page 4-5