Table of Contents
Advertisement
The following methods are options on how to make a
Dynamic Priority Change. The result of all the
methods is the same. You can use the options
interchangeably depending on your preference and
the programmed functions.
•
Making a Dynamic Priority Change via the
preprogrammed Dynamic Priority button:
a) When the radio locks onto the channel
designated as the new Priority-Two channel,
press the preprogrammed Dynamic Priority
button.
The radio continues scanning the remaining
channels in the list.
•
Making a Dynamic Priority Change via the radio
menu:
a) Press the Menu Select button directly below
DynP to change the priority of a non-priority
channel in the scan list to Priority-Two.
b) Press
momentarily to exit the scan list and
resume scanning.
Deleting a Nuisance Channel
If a channel continually generates unwanted calls or
noise (termed a "nuisance" channel), you can
temporarily remove the unwanted channel from the
scan list.
This capability does not apply to priority channels or
the designated transmit channel.
Note:
Deleting a nuisance channel is only possible
through the preprogrammed Nuisance
Channel Delete button. This feature is not
accessible through the menu.
When the radio is locked onto the channel to be
deleted, perform one of the following actions:
•
Press the preprogrammed Nuisance Delete
button.
•
or to NuisDel and press the Menu Select
button directly below NuisDel.
The radio continues scanning the remaining channels
in the list.
Restoring a Nuisance Channel
To restore the deleted nuisance channel, perform
one of the following actions:
•
Stop and restart a scan.
75
English
Advertisement
Table of Contents
