Table of Contents
Advertisement
English
Scan
This feature allows you to monitor traffic on different
channels by scanning a preprogrammed list of channels.
Turning Scan On or Off
Perform one of the following actions:
•
Press the preprogrammed Scan button to toggle
Scan On or Scan Off to initiate or stop scan.
•
Turn the preprogrammed Scan switch to the
Scan on or Scan off position to initiate or stop
scan.
•
or to Scan and press the Menu Select button
directly below Scan.
If the scan is enabled, the display shows Scan on
and the scan status icon.
If the scan is disabled, the display shows Scan Off.
The radio returns to the Home screen.
82
Making a Dynamic Priority Change
(Conventional Scan Only)
While the radio is scanning, the dynamic priority change
feature allows you to temporarily change any channel in a
scan list (except for the Priority-One channel) to the
Priority-Two channel.
This change remains in effect until scan is turned off. Scan
then reverts to the preprogrammed (original) setting.
•
Making a Dynamic Priority Change using the
preprogrammed Dynamic Priority button:
a. When the radio locks onto the channel
designated as the new Priority-Two channel,
press the preprogrammed Dynamic Priority
button.
The radio continues scanning the remaining
channels in the list.
Deleting a Nuisance Channel
If a channel continually generates unwanted calls or noise
(termed "nuisance" channel), you can temporarily remove
the unwanted channel from the scan list.
Advertisement
Table of Contents
