Install Ferrite Core - Kodak S3120 Max User Manual

Install ferrite core

12
If you are using an Ethernet cable, install the provided ferrite core. Without a
properly attached ferrite core, the scanner may cause interference to nearby
wireless devices.
1. Open the ferrite core that came with the scanner.
2. Wrap the Ethernet cable around the ferrite core as shown. Place it
approximately 3 in./7.6 cm from the end of the Ethernet cable that will be
plugged into the scanner.
3. Close the ferrite core. Be careful not to pinch the Ethernet cable.
A-61981 20 April 2022