Change The Presser Foot; Operations And Stitch Control Buttons; Reverse Button; Needle Up/Down - Singer HD6620C Instruction Manual

Change the Presser Foot

1. Make sure that the needle is in the highest position and the
presser foot is lifted. The presser foot release lever extends
out the back of the presser foot holder. Press this lever to
release the presser foot.
2. To attach a presser foot to the holder, place the desired
presser foot with its pin directly under the slot in the
presser foot holder. Lower the presser foot lifter and the
presser foot will snap into place.
Note: If you find it difficult to place the presser foot in the
correct position, keep the release lever pressed while
lowering the presser foot. Use your thumb to carefully
guide the presser foot into the correct position and it will
snap into place.

Operations and Stitch Control Buttons

The Machine Operation Controls are used to operate the machine, and are found on the sewing head of the machine. On the Stitch
Control Panel (next to the display) you find buttons used to adjust and select stitches.
Each functionality is listed and described further below.

Reverse Button

The Reverse Button has different functionality depending on what stitch that is selected.
Stitch 00–05
Press and hold the Reverse button to sew in reverse. Release it to resume sewing forward. The machine sews in
reverse only as long as the reverse button is pressed.
Stitch 06–19, 28–99
Press the Reverse button and the machine sews 3 tie-off stitches then stops automatically.
Reverse has no functionality for buttonholes, darning and button sewing stitches.

Needle Up/Down

Press Needle Up/Down to move the needle down or up. You can also tap the foot control to raise or lower needle.

Menu/Sound On/Off

Press to toggle between the Menus. There are three menus, Utility/Decorative Stitches, Stitch Width and Stitch
Length. When a menu is selected, a light next to the icon becomes lit.
This button is also used to turn off the machine sound. Press and keep depressed for 2 seconds with the machine
turned on, when an audio beep is heard, the sound is turned off. Press for 2 seconds until two audio beeps are
heard and the sound is turned back on. The setting remains even if the machine is turned off.
16 – Preparations
English
1
2