Sewing; Start To Sew - Straight Stitch; Change Needle Position; Change Sewing Direction - Singer HD6620C Instruction Manual

SEWING

Sewing
Next to each stitch or sewing technique described in this
section of the manual is a chart showing the recommended
settings and presser foot. See sample of the chart to the right.
Note: Some fabrics have a lot of excess dye which can cause
discoloration on other fabric but also on your sewing machine.
This discoloring may be very difficult or impossible to remove.
Fleece and denim fabric in especially red and blue often
contain a lot of excess dye. If you suspect that your fabric/
ready-to-wear garment contains a lot of excess dye, always
pre-wash it before sewing to avoid the discoloring on your
machine.
Note: For best sewing result, use the same thread on top and
bobbin. If sewing with specialty/decorative threads, use
regular sewing thread in the bobbin.
Start to Sew – Straight Stitch
Set your machine for straight stitch (see chart to the right).
Raise the presser foot and position the fabric under it, next to a
seam allowance guide line on the needle plate. On the bobbin
cover there is a 1/4" (6mm) guide line.
Place the top thread underneath the presser foot.
Lower the needle to the point where you want to start. Bring
the threads toward the back and lower the presser foot. Press
the foot control. Gently guide the fabric along the seam guide
letting the machine feed the fabric (A). If the bobbin thread
isn't pulled up, it will be automatically as you start to sew.
To secure the beginning of a seam, press and hold the reverse
button. Sew a few reverse stitches. Release the reverse button
and the machine will sew forward again (B).

Change Needle Position

Some sewing is done more easily by changing the needle
position, e.g., topstitching a collar or sewing in a zipper. The
needle position is adjusted with the Stitch Width button (see
page 17).

Change Sewing Direction

To change sewing direction, stop the machine. Press the
Needle Stop button to activate the Needle Down position. The
needle is brought down into the fabric.
Raise the presser foot.
Pivot the fabric around the needle to change sewing direction
as desired. Lower the presser foot and continue sewing in the
new direction.
18 – Sewing
English
A B
A. Stitch
B. Presser foot
C. Stitch width in mm
D. Stitch length in mm
E. Thread tension
Set up for straight stitch
A
3.5 2.5 3-5
C D E
3.5 2.0–4.0 3–5
B