Table of Contents
Advertisement
Free Arm/Removable Accessory Tray
Store presser feet, bobbins, needles and other accessories in the
accessory tray so that they are easily accessible.
Keep the accessory tray on the machine to provide a larger, flat
work surface.
Use the free arm to facilitate sewing trouser legs and sleeve
hems. To use the free arm, slide off the accessory tray. When
attached, a hook keeps the accessory tray securely attached to
the machine. Remove the tray by sliding it to the left.
Presser Foot Lifter
The presser foot lever is located at the side of the sewing
machine head. The lever is used to raise and lower the presser
foot. Raise the lever up for machine threading, lower it for
sewing.
When the foot is in the raised position, press the lever further
upward for more room under the presser foot. This is good for
sewing thick projects.
Thread Knife
To use the thread knife, pull the thread from back to front as
illustrated. Doing this will leave the thread ends long enough
so that the needle doesn't become unthreaded when you start to
sew again.
Change the Presser Foot
1. Make sure that the needle is in the highest position and the
presser foot is lifted. The presser foot release lever extends
out the back of the presser foot holder. Press this lever to
release the presser foot.
2. To attach a presser foot to the holder, place the desired
presser foot with its pin directly under the slot in the presser
foot holder. Lower the presser foot lifter and the presser
foot will snap into place.
Note: If you find it difficult to place the presser foot in the
correct position, keep the release lever pressed while lower-
ing the presser foot. Use your thumb to carefully guide the
presser foot into the correct position and it will snap into
place.
8
English
1
2
Advertisement
Table of Contents
