Table of Contents
Advertisement
g Tally indicator
The indicator lights up when a red tally signal is input to the camera.
When an abnormality occurs, the tally indicator flashes to indicate a
warning.
h PEAKING knob
Rotate clockwise to adjust the picture sharpness to make lens
focusing easier. This has no effect on the output signal of the camera.
i CONTRAST knob
Adjust the contrast of the screen. This has no effect on the output
signal of the camera.
j BRIGHT knob
Adjust the brightness of the screen. This has no effect on the output
signal of the camera.
k TALLY switch
Used to control the tally indicator on the viewfinder.
HIGH: The tally indicator brightness is set to high.
OFF: The tally indicator is disabled.
LOW: The tally indicator brightness is set to low.
l ZEBRA (zebra pattern) switch
Use to control the zebra pattern display.
ON: Display the zebra pattern.
OFF: Do not display the zebra pattern.
m DISPLAY switch
Use to control the display of text information.
ON: Display text information.
OFF: Do not display text information.
Also used when switching to full-screen display mode or reduced
display mode.
Note
There may be a mismatch between the DISPLAY switch ON/OFF state and
the actual ON/OFF operation, depending on the camera settings.
n MIRROR switch
Used to reverse the image display on the monitor screen horizontally
or vertically when the viewfinder barrel is raised up or rotated.
L/R (left/right): Reverse the image horizontally.
OFF: Do not reverse the image.
B/T (bottom/top): Reverse the image vertically.
o Viewfinder cable
p Microphone holder
Connection and Setup
Connecting to a Camera Control Unit
When operating the camera in a system with a camera control unit
(CCU), connect the CCU connector of the camera and the
CAMERA connector of the CCU using an optoelectric composite
cable.
When required, secure the cable, using the supplied cable clamp
belt.
If connecting an HXCU-TX70 HD Camera Control Unit, refer to the
operating instructions for the HXCU-TX70.
Attaching the cable clamp belt
1
Insert the belt bracket C into hole A or B of the cable
clamp belt.
C
2
1 Remove the screw-hole cover on the top rear of the
camera and 2 secure the cable clamp belt to the camera
using the two supplied screws (+B3×10).
14
B
A
Advertisement
Table of Contents
