Table of Contents
Advertisement
MAINTENANCE AND TROUBLESHOOTING
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the exercise bike is used.
Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
If lines appear in the console display, see HOW TO
CHANGE CONSOLE SETTINGS on page 20 and
adjust the contrast level of the display.
If the console does not display your heart rate when
you use the handgrip heart rate monitor, see step 5 on
page 16.
If a replacement power adapter is needed, call the
telephone number on the cover of this manual.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while the
resistance is adjusted to the highest setting, the drive
belt may need to be adjusted. Before you adjust the
drive belt, unplug the power adapter.
See assembly step 11 on page 11. Using
an adjustable wrench, turn the Right Pedal (21)
counterclockwise and remove it. Note: Turn the Right
Pedal clockwise when you reattach it.
See assembly step 10 on page 10. Remove
the Seat Post (6). Then, loosen the Seat Post Knob
(27), pull it outward, and use an adjustable wrench to
remove it.
See EXPLODED DRAWING B on page 27. Using
a standard screwdriver, release the Front Shield Cover
(9) and slide it out of the way.
Next, remove the two #8 x 16mm Screws (34) from
the Rear Shield Cover (7). Then, use a standard
screwdriver to remove the Rear Shield Cover.
Next, remove the twelve #8 x 16mm Screws (34) and
the three M4 x 22mm Screws (84) from the Right and
Left Shields (10, 11). Then, remove the Right Shield.
See the drawing below. Loosen the M6 x 20mm
Screw (48). Next, tighten the M10 x 65mm Screw (51)
until the Drive Belt (54) is tight. Then, retighten the
M6 x 20mm Screw.
Reattach all the parts that you removed and plug in the
power adapter.
21
48
51
54
Advertisement
Table of Contents
